Jump to content


All Advert Types Sort by                Order  

Views - 1209

Time Left - 238 Days, 14 Hours

Location: Tennessee

$5,500.00 Runoffs Rental/ Brand New Esr Build


in Spec Miata Rentals by Jim Drago

We will have a brand new, super fast 2000 Sm ready for the Runoffs. I have decided to offer it up for rent with full trackside support at the 2017 Runoffs. This car is 100% capable of winning the event with the right driver. The car will be literally brand new, inside and out. It is as good as we can build, it will be driven by me in 18. We do...

Views - 1211

Time Left - 182 Days, 16 Hours

Location: Tennessee

For Sale

$3,200.00 2001 Vvt Esr Race Engine, Dyno Time Only


in Engine & Drivetrain by Jim Drago

We are selling this beautiful engine as a non performer, our loss is your gain. Occasionally we get an engine that falls just under our cutoff line on performance. We have strict standards of what we allow to leave in every car we build. Most every 1999/00 Miata we build will dyno at 125-128 hp and break in to 126-128.5 hp. This one fell short a...

Views - 3451

Time Left - 118 Days, 10 Hours

Location: Tennessee

For Sale

$1,200.00 Rebuilt Transmissions The Best Available!


in Engine & Drivetrain by Jim Drago

We are offering our Race ready rebuilt transmissions to the SM community. These transmission are fully gone through, All the synchros,sliders and shift forks are changed. We harden the shift forks for improved durability. We start with a street version transmission, not a wore out trans that came out of a race car. We have sold over 200 of these...

Views - 3005

Time Left - 118 Days, 10 Hours

Location: Tennessee

For Sale

$1,250.00 Torsen Swaps /torsens


in Engine & Drivetrain by Jim Drago

These swaps will bolt right into your 90-93 SM. This will replace the fragile Mazda Comp differential and give you years of worry free racing. The swap comes with all the parts necessary to install into your car. It comes with the 4:30 torsen differential, the aluminum housing, both CV axles and the drive shaft along with all the necessary hardw...

Views - 2852

Time Left - 118 Days, 10 Hours

Location: Tennessee

For Sale

$225.00 Blueprinted Rear Knuckles


in Suspension by Jim Drago

We are offering race ready ready knuckles. These come with new Mazda bearings that we go through, replace the inferior quality balls with the best available, pack with our proprietary grease( special grease :optimist: ), then press into rear knuckles. We also install a new bushing. They are ready to install on the car. These roll great, better...

Views - 3323

Time Left - 118 Days, 10 Hours

Location: Tennessee

For Sale

$150.00 Tunnel Notch Out Panel


in Body & Interior by Jim Drago

We developed an insert that welds into the floor/tunnel area. This insert adds almost three inches of floor space to better mount your seat. Most seats in Miata's are mounted off center or crooked because of interference with the tunnel. Rather than beat the tunnel with a Big hammer, you call install this piece in about 30 minutes and have a nic...

Views - 3305

Time Left - 118 Days, 10 Hours

Location: Tennessee

For Sale

$125.00 Ballast System


in Body & Interior by Jim Drago

After seeing many of the ways people install ballast in their cars, we decided there had to be a better way. What we decided to do is to secure the weight on the passengers side seat mounts. These mounts are designed to easily carry 200+ lbs securely. Our system comes with a steel base plate ( 17.5 lbs) that mounts securely to the four passenger...

Powered by Classifieds