Jump to content

Bushing Press tools


Bushing Press tools

Upper left is solid with a pocket to cover the metal tube and is for pressing the Bushing out.
Can be used for pressing in too but not really needed.

Upper right goes on the exit side to allow the bushing to exit.

Bottom is used for pressing the OEM Bushing back in, you need to go a little past to get the rubber flange to pop out the other side.
Chamfers for locating to make concentric with the contol arm tube. Bottom piece is ground to clear welds on the arm.

You use these in a table vise.



    Photo
    Steve Scheifler
    10-14-2015 02:09 PM
    Nice!

    Selling these?
    • Report

    Not really, I could get you a set. I made one up for a guy in SoCal.

     

    PM me,

    • Report
    Photo
    CarbonRacer
    04-26-2016 08:51 AM

    Do you have a set for the Florida guys?

    • Report