Just carrying this topic over from the old site...
My plan is to wire the stock TPS signal into my Traqmate and want to confirm the wiring. I am assuming we run a 12v signal and ground into the Traqdata on the correct terminals.
The signal wire from the TPS would go from the wire on center pin (labeled TL in the service manual) to one of the analog inputs on the Traqmate with a 1k ohm resistor soldered in series.
Is that correct?
Thanks much!
TPS feed into Traqmate
Started by
l8tbreakr
, 01-18-2011 02:39 PM
#1
Posted 01-18-2011 02:39 PM
#2
Posted 02-06-2011 11:35 AM
I'm pretty sure this only gives you WOT.
Ben Schaut
------------
SCHAUT SPEED Motorsports
Race Technology - Traqmate
Cobalt Friction - Amsoil
info@schautspeed.com
248.939.6108
------------
WHRRI / GLDiv
'92 SM - #66
------------
SCHAUT SPEED Motorsports
Race Technology - Traqmate
Cobalt Friction - Amsoil
info@schautspeed.com
248.939.6108
------------
WHRRI / GLDiv
'92 SM - #66
#3
Posted 02-26-2011 10:10 AM
I'm pretty sure this only gives you WOT.
I think youre correct for the NA cars. It looks to me in the fsm the NA auto trans cars got a variable resistance tps, but not the 5 speeds. Looking at aftermarket tps potentiometers.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users