Trans Tunnel Notch Panel Question
#1
Posted 02-04-2017 10:58 AM
Do I cut out the factory mount and reweld it to the new panel, or trim the panel around the mount and weld it in place?
Any advice is appreciated. TIA
Chase
Chase H
#63 1.6L
Cincinnati Region SCCA - 2014 Rookie of the Year
#2
Posted 02-04-2017 11:23 AM
3 podium finishes
2 2013 NASA nats
1 2013 Scca runoffs
#3
Posted 02-04-2017 12:10 PM
I just weld a nut to a backer plate and weld it to the back side of the tunnel notch. 7/16-20 thread.
- Killian likes this
V2 Motorsports
#4
Posted 02-04-2017 05:10 PM
Last na that I installed a esr notch panel in I left the factory belt mount attached to the chassis then mock fit the notch panel. After fitting I stuck a felt pen thru the factory hole from under side to mark centerline. Used a 1-1/2 hole saw to open up around factory hole location on panel. Then welded around it
Thanks Chris, I appreciate the info.
I just weld a nut to a backer plate and weld it to the back side of the tunnel notch. 7/16-20 thread.
Thanks Ralph! That sounds like the easiest solution...I think I'll go with that!
Chase H
#63 1.6L
Cincinnati Region SCCA - 2014 Rookie of the Year
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users