1. Would this satisfy GCR Section 9.3.41 assuming appropriate grade hardware is used?
2. Have any of you used this particular seat bracket?
3. How high would it position the seat relative to the stock sliders?
Thanks.
9.3.41. SEATS
The driver’s seat shall be a one-piece bucket-type seat and shall be
securely mounted. The back of the seat shall be firmly attached to the
main roll hoop, or its cross bracing, so as to provide aft and lateral support.
Seats homologated to and mounted in accordance with FIA standard
8855-1999, or FIA.Standard.8862-2009 or higher need not have
the seat back attached to the roll structure. Seats with a back not attached
to the main roll hoop or its cross bracing may not be mounted to
the stock runners unless they are the FIA homologated seats specified in
an FIA homologated race car. The homologation labels must be visible.
Seat supports shall be of the type listed on FIA technical list No.12 or
No. 40 (lateral, bottom, etc). Passenger seat back–if a folding seat, it
shall be securely bolted or strapped in place.