Lap belt anchor, driver's right side, '99
#1
Posted 02-03-2013 12:26 PM
So, I suppose that means drilling a new hole in the floor or tunnel for the right side lap belt, right?
Any suggestions or pictures? Or is it very straightforward - just drill the hole where it fits best?
TIA.
#2
Posted 02-03-2013 06:14 PM
#3
Posted 02-04-2013 08:57 AM
Dave Wheeler
Advanced Autosports, the nations most complete Spec Miata shop
Author, Spec Miata Constructors Guide, version 1 and 2.0
Building Championship winning cars since 1995
4 time Central Division Spec Miata Champion car builder 2012-2013-2014-2017
Back to Back June Sprints Spec Miata 1-2 finishes 2016 and 2017
5 time June Sprints winner in Mazda's
6 Time Northern Conference Champion Car Builder
2014 SCCA Majors National point Champion car builder
2014 SCCA Runoffs winner, T4 (Bender)
2014 Central Division Champion, ITS (Wheeler)
2013 Thunderhill 25 hour winning crew chief
2007 June Sprints winner, (GT1, Mohrhauser)
Over 200 race wins and counting.
www.advanced-autosports.com
dave@advanced-autosports.com
608-313-1230
#4
Posted 02-04-2013 09:28 AM
I welded in a doubler plate with a nut on it.
http://www.ogracing....arness-mounting
Duncan
Those nice sharp corners look like they'd be good at piercing and tearing through sheet metal. Might want to radius them on a grinder.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users