...are posted:
http://www.scca.com/.../cars-and-rules
February 2016 Prelims
#1
Posted 01-08-2016 11:30 AM
#2
Posted 01-08-2016 11:37 AM
Spec Miata
1. #18503 (david wheeler) Floor Drop Plate Clarification
In GCR section 9.1.7.7.a., make the following change:
"The driver's seat shall be replaced with a one-piece bucket-type race seat. All seat mountings shall be reinforced. Factory seat tracks/ brackets may be modified, reinforced, and/or removed to facilitate replacement mountings provided they perform no other function. The passenger seat must be removed. The transmission tunnel may be modified for the purpose of installing a competition driver seat. The driver's side floor pan may be modified to accommodate larger/taller drivers. All modifications shall be contained between the transmission tunnel, driver's side rocker, rear bulkhead and no more than 24" forward of the rear bulkhead. The modification shall not extend below the factory floor stiffener/frame rail. The steel used in the modification shall be no thinner than .060".058". All modifications shall be welded in place. This modification shall serve no other purpose other than seating position."
#3
Posted 01-08-2016 12:15 PM
NOTE: This preliminary version of the Club Racing Technical Bulletin is provided at this time as a service to the membership. These items may be corrected and will not be official until published on the Fastrack page of the scca.com website on or about January 20.
Spec Miata
1. #18503 (david wheeler) Floor Drop Plate Clarification
In GCR section 9.1.7.7.a., make the following change:
"The driver's seat shall be replaced with a one-piece bucket-type race seat. All seat mountings shall be reinforced. Factory seat tracks/ brackets may be modified, reinforced, and/or removed to facilitate replacement mountings provided they perform no other function. The passenger seat must be removed. The transmission tunnel may be modified for the purpose of installing a competition driver seat. The driver's side floor pan may be modified to accommodate larger/taller drivers. All modifications shall be contained between the transmission tunnel, driver's side rocker, rear bulkhead and no more than 24" forward of the rear bulkhead. The modification shall not extend below the factory floor stiffener/frame rail. The steel used in the modification shall be no thinner than.060".058". All modifications shall be welded in place. This modification shall serve no other purpose other than seating position."
Jason Kohler
#84 SM
www.youtube.com/user/speedengineering
#4
Posted 01-20-2016 11:13 AM
Feb
http://cdn.growasset....pdf?1453302260
Just what mentioned above.
J~
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users