9 replies to this topic

[Sphinx]

How are you guys passing your hoses from the trunk to the passenger compartment?  My NA seemed to have a bazillion holes to run them through, but the NB seems much more limited and none are large enough to accommodate the hoses.

[chris haldeman]

Drivers side where the large rear tin meets seat belt tower

[Sphinx]

Drivers side where the large rear tin meets seat belt tower

 

I can fit two fingers through there, hardly enough room for the hoses.  Trim the panel?

[chris haldeman]

Whatever it takes. If you trim it alittle door edge guard from auto parts store will keep the edge from cutting into hoses

[Tom Hampton]

By putting it on the passenger floor.

[Nathan Pring]

I can fit two fingers through there, hardly enough room for the hoses.  Trim the panel?

 

I just put mine through the same, I think it only squeezes the foam insulation and not the hose so you should be good

[Jamz14]

From the trunk, spiralled around the fuel line to the engine bay, through the firewall to the driver.

[Sphinx]

Any reason not to have it come out from the passenger side?  There's a battery cut-off switch in that area - should that be avoided?  The routing is slightly better than through the driver's side.

[chris haldeman]

Passenger side is perfectly fine.

[Jackie Dankos]

I have used through the hull fittings. You can get them from Grainger or McMaster Car.

You drill holes to fit and you then have quick connect fittings to ease maintenance.