How are you guys passing your hoses from the trunk to the passenger compartment? My NA seemed to have a bazillion holes to run them through, but the NB seems much more limited and none are large enough to accommodate the hoses.
Path for coolsuit hoses from trunk?
#1
Posted 07-12-2020 07:11 PM
#2
Posted 07-13-2020 10:12 AM
3 podium finishes
2 2013 NASA nats
1 2013 Scca runoffs
#3
Posted 07-13-2020 02:34 PM
Drivers side where the large rear tin meets seat belt tower
I can fit two fingers through there, hardly enough room for the hoses. Trim the panel?
#4
Posted 07-13-2020 06:41 PM
3 podium finishes
2 2013 NASA nats
1 2013 Scca runoffs
#5
Posted 07-13-2020 11:34 PM
- Ron Alan and Bench Racer like this
-tch
Build: www.tomhampton.info
video: vimeo.com/tomhampton
Support: X-Factor Racing
I didn't lose, I just got outspent!
#6
Posted 07-15-2020 09:54 AM
I can fit two fingers through there, hardly enough room for the hoses. Trim the panel?
I just put mine through the same, I think it only squeezes the foam insulation and not the hose so you should be good
2019 SeDIV SMSE Champion
#7
Posted 07-15-2020 03:22 PM
#8
Posted 07-15-2020 09:59 PM
Any reason not to have it come out from the passenger side? There's a battery cut-off switch in that area - should that be avoided? The routing is slightly better than through the driver's side.
#9
Posted 07-16-2020 09:20 AM
3 podium finishes
2 2013 NASA nats
1 2013 Scca runoffs
#10
Posted 07-17-2020 07:27 AM
I have used through the hull fittings. You can get them from Grainger or McMaster Car.
You drill holes to fit and you then have quick connect fittings to ease maintenance.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users