If you read my other thread you see that the motor let go, I have a 74k used motor from a 99 and will be installing it. Prior to install I want to make sure it's ready to go, my question is short of tearing it down, what should I check and what do I need for install? It's a complete long block so I'll be reusing intake and exh mani, MAF, Alt, coil packs etc...
Here's the list... tell me what I am missing or what else I need to do before I place my order.
Gaskets - intake, exhaust mani, H2O pump, MAF, Manifold to "A" pipe, "A" pipe to "B" pipe,
Hoses - Upper and Lower radiator, (2) heater hoses,
Clutch M/C
Timing Belt
Motor Mounts (broken)
Used Clutch and resurfaced Flywheel
Pressure Plate?? (Can these be resurfaced) (my car had a shudder on takeoff)
Should I replace front and rear main seals and/or cam seals
Throw-out Bearing
Cleaned Injectors
Radiator cap
Air Filter
Shift Bushings and Boots
Plugs
RTV Sealant
Thermostat
Belts
PVC
Fluids