View New Content

Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

0

Roll Cage: Seat and Cage sides, final fit

Posted by Tom Hampton , 02-15-2011 · 1,390 views

Last weekend Iâ€™d decided that I needed to notch the transmission tunnel to make room for the seat. So, today I got down to it. Iâ€™d done some banging with the hammer beforeâ€¦and Iâ€™d noticed a squeal coming from the driveshaft the last time I rolled the car. I was guessing that I mushed something over into the driveshaft. Sure enough, Iâ€™d pushed the heat shield overâ€¦and the edge was rubbing against it. I removed the heat shield and the catalytic converter. Iâ€™ll figure out what to do after everything is back in place.

Continue reading Roll Cage: Seat and Cage sides, final fit

Jim Daniels - FIG

02-15-2011 08:03 AM

im enjoying your blog so much that im not motivated to write mine, keep up good work!!

- Tom Hampton likes this
Report

Tom Hampton

02-15-2011 09:48 AM

Jim-

Just tell me all your secrets. I'll build mine according to your spec, and add something to the final paint scheme, like: "Designed by Jim Daniels." or whatever other phrase you prefer.

I'm sure we could work something out.

-tch

Report

Tom Hampton

02-15-2011 12:48 PM

Seriously though....thank you!

A compliement like that means a lot coming from someone who has literally seen it all. Very cool.

I'm mostly "shooting in the dark" based on books and information gleened from this site and sm.com.